SIMS of organic layers with unknown matrix parameters: Locating the interface in dual beam argon gas cluster depth profiles

Four simple methods are evaluated to determine their accuracies for establishing the interface location in secondary ion mass spectrometry intensity depth profiles of organic layers where matrix effects have not been measured. Accurate location requires the separate measurement of each ion's matrix factor. This is often not possible, and so estimates using matrix-less methods are required. Six pure organic material interfaces are measured using many secondary ions to compare their locations from the four methods with those from full evaluation with matrix terms. For different secondary ions, matrix effects cause the apparent interface positions to vary over 20 nm. The shifts in the intensity profiles on going from a layer of P into a layer of Q are in the opposite direction to that for going from Q into P, so doubling layer thickness errors. The four methods are as follows: M1, use of the median interface position in the intensity profiles for the five lightest ions for 15 ≤ m/z ≤ 150; M2, extrapolation of the position for each ion to m/z = 0 for ions with m/z ≤ 150; M3, as M2 but for m/z ≤ 300; and M4, the extreme positions for all m/z ≤ 100. Comparison with the location using matrix terms shows their ranking, from best to worst, to be M4, M3, M1, and M2 with average errors of 10%, 12%, 14%, and 17%, respectively, of the profile interface full widths at half maximum. Use of pseudo-molecular ions is very much poorer, exceeding 50%, and should be avoided.     

PowerSlicing to determine fluorescence lifetimes of water-soluble organic matter derived from soils,plant biomass,and animal manures

Time-resolved fluorescence spectroscopy was used to characterize water-soluble organic matter (WSOM) which plays an important role in soil ecosystem processes. WSOM was extracted from plant biomass, animal manures, and soils from controlled cropping systems studies with known histories of organic amendments. Lifetime constants were derived using the multi-way PowerSlicing method which provides a non-iterative, multi-exponential fitting of decay profiles. The lifetimes obtained by PowerSlicing were not significantly different from those obtained using the traditional discrete components analysis. The three components attributed to WSOM had lifetimes of 0.38 ± 0.14, 2.11 ± 0.72, and 7.08 ± 1.18 ns which are in agreement with previous lifetimes reported for humic substances. This study provides further support for the new paradigm for the structure of soil organic matter where the organic matter is composed of low-molecular-weight components held together by hydrogen bonding and hydrophobic interactions.     

Wave packet simulation of nonadiabatic dynamics in highly excited 1,3-dibromopropane

We have conducted wave packet simulations of excited-state dynamics of 1,3-dibromopropane (DBP) with the aim of reproducing the experimental results of the gas-phase pump-probe experiment by Kotting et al. [ Kotting, C. ; Diau, E. W.-G. ; S?lling, T. I. ; Zewail, A. H. J. Phys. Chem. A 2002, 106, 7530 ]. In the experiment, DBP is excited to a Rydberg state 8 eV above the ground state. The interpretation of the results is that a torsional motion of the bromomethylene groups with a vibrational period of 680 fs is activated upon excitation. The Rydberg state decays to a valence state, causing a dissociation of one of the carbon bromine bonds on a time scale of 2.5 ps. Building the theoretical framework for the wave packet propagation around this model of the reaction dynamics, the simulations reproduce, to a good extent, the time scales observed in the experiment. Furthermore, the simulations provide insight into how the torsion motion influences the bond breakage, and we can conclude that the mechanism that delays the dissociation is solely the electronic transition from the Rydberg state to the valence state and does not involve, for example, intramolecular vibrational energy redistribution (IVR).     

Multiblock variance partitioning: a new approach for comparing variation in multiple data blocks

More than one multi-informative analytical technique is often applied when describing the condition of a set of samples. Often a part of the information found in these data blocks is redundant and can be extracted from more blocks. This study puts forward a method (multiblock variance partitioning—MVP) to compare the information/variation in different data blocks using simple quantitative measures. These measures are the unique part of the variation only found in one data block and the common part that can be found in more data blocks. These different parts are found using PLS models between predictor blocks and a common response. MVP provides a different view on the information in different blocks than normal multiblock analysis. It will be shown that this has many applications in very diverse fields such as process control, assessor performance in sensory analysis, efficiency of preprocessing methods and as complementary information to an interval PLS analysis. Here the ideas of the MVP approach are presented in detail using a study of red wines from different regions measured with GC-MS and FT-IR instruments providing different kinds of data representations.     

Synchrotron X-ray charge-density study of coordination polymer [Mn(HCOO)2(H2O)2]infinity

Three high-quality single-crystal X-ray diffraction data sets have been measured under very different conditions on a structurally simple, but magnetically complex, coordination polymer, [Mn(HCOO)(2)(H(2)O)(2)](infinity) (1). The first data set is a conventional 100(2) K Mo(Kalpha) data set, the second is a very high resolution 100(2) K data set measured on a second-generation synchrotron source, while the third data set was measured with a tiny crystal on a high brilliance third-generation synchrotron source at 16(2) K. Furthermore, the magnetic susceptibility (chi) and the heat capacity (C(p)) have been measured from 2 to 300 K on pressed powder. The charge density of 1 was determined from multipole modeling of the experimental structure factors, and overall there is good agreement between the densities obtained separately from the three data sets. When considering the fine density features, the two 100 K data sets agree well with each other, but show small differences to the 16 K data set. Comparison with ab initio theory suggests that the 16 K APS data set provides the most accurate density. Topological analysis of the metal-ligand bonding, experimental 3d orbital populations on the Mn atoms, and Bader atomic charges indicate quite ionic, high-spin metal atoms. This picture is supported by the effective moment estimated from the magnetization measurements (5.840(2) mu(B)), but it is at variance with earlier spin density measurements from polarized neutron diffraction. The magnetic ordering originates from superexchange involving covalent interactions with the ligands, and non-ionic effects are observed in the static deformation density maps as well as in plots of the valence shell charge concentrations. Overall, the present study provides a benchmark charge density that can be used in comparison with future metal formate dihydrate charge densities.     

Identification of the radical anions of C2N4S2 and P2N4S2 rings by in situ EPR spectroelectrochemistry and DFT calculations

The previously unknown radical anions of unsaturated E2N4S2 ring systems (E=RC, R2NC, R2P) can be generated voltammetrically by the one-electron reduction of the neutral species and, despite half-lives on the order of a few seconds, have been unambiguously characterized by electron paramagnetic resonance (EPR) spectroelectrochemistry using a highly sensitive in situ electrolysis cell. Cyclic voltammetric studies using a glassy-carbon working electrode in CH3CN and CH2Cl2 with [nBu4N][PF6] as the supporting electrolyte gave reversible formal potentials for the [E2N4S2]0/- process in the range of -1.25 to -1.77 V and irreversible peak potentials for oxidation in the range of 0.66 to 1.60 V (vs the Fc+/0 couple; Fc=ferrocene). Reduction of the neutral compound undergoes an electrochemically reversible one-electron transfer, followed by the decay of the anion to an unknown species via a first-order (chemical) reaction pathway. The values of the first-order rate constant, kf, for the decay of all the radical anions in CH2Cl2 have been estimated from the decay of the EPR signals for (X-C6H4CN2S)2*-, where X=4-OCH3 (kf=0.04 s(-1)), 4-CH3 (kf=0.02 s(-1)), 4-H (kf=0.08 s(-1)), 4-Cl (kf=0.05 s(-1)), 4-CF3 (kf=0.05 s(-1)), or 3-CF3 (kf=0.07 s(-1)), and for [(CH3)3CCN2S]2*- (kf=0.02 s(-1)), [(CH3)2NCN2S]2*- (kf=0.05 s(-1)), and [(C6H5)2PN2S]2*- (kf=0.7 s(-1)). Values of kf for X=4-H and for [(CH3)2NCN2S]2*- were also determined from the cyclic voltammetric responses (in CH2Cl2) and were both found to be 0.05 s(-1). Possible pathways for the first-order anion decomposition that are consistent with the experimental observations are discussed. Density functional theory calculations at the UB3LYP/6-31G(d) level of theory predict the structures of the radical anions as either planar (D2h) or folded (C2v) species; the calculated hyperfine coupling constants are in excellent agreement with experimental results. Linear correlations were observed between the voltammetrically determined potentials and both the orbital energies and Hammett coefficients for the neutral aryl-substituted rings.     

pH-dependence of the aqueous electrochemistry of the two-electron reduced alpha-[Mo18O54(SO3)] sulfite Dawson-like polyoxometalate anion derived from its triethanolammonium salt

The electrochemistry of the Dawson-like sulfite polyoxometalate anion alpha-[Mo18O54(SO3)2]6-, derived from the TEAH6{alpha-[Mo18O54(SO3)2]} salt (TEAH+ is the triethanolammonium cation; pKa=7.8), has been investigated in aqueous media using cyclic and rotated disk voltammetry at glassy carbon electrodes and bulk electrolysis, with a focus on the pH-dependence for oxidation to alpha-[Mo18O54(SO3)2]4-. In buffered media at pH>or=4, the cyclic voltammetric response for alpha-[Mo18O54(SO3)2]6- reveals two partially resolved one-electron oxidation processes corresponding to the sequential generation of alpha-[Mo18O54(SO3)2]5- and alpha-[Mo18O54(SO3)2]4-. At lower pH, using electrolytes containing sulfuric acid, the two waves coalesce but the individual apparent E0' reversible formal potential values for the two processes can be extracted down to pH 2 by assuming that reversible protonation accompanies fast electron transfer. The results for 2相似文献   

Dispersing hash functions

We define a family of functions F from a domain U to a range R to be dispersing if for every set S ? U of a certain size and random h ∈ F, the expected value of ∣S∣ – ∣h[S]∣ is not much larger than the expectation if h had been chosen at random from the set of all functions from U to R. We give near‐optimal upper and lower bounds on the size of dispersing families and present several applications where using such a family can reduce the use of random bits compared to previous randomized algorithms. A close relationship between dispersing families and extractors is exhibited. This relationship provides good explicit constructions of dispersing hash functions for some parameters, but in general the explicit construction is left open. © 2008 Wiley Periodicals, Inc. Random Struct. Alg., 2009